Recommended for: Installed Sound. Front-Panel Interface — Completely configure the amplifier using an intuitive front-panel interface. If any of the links above result in strange characters in your browser, please right-click the file to save it to your computer.
BLU link Channels 2 Sensitivity for full rated power at 8 ohms 0. If the text box is left empty, the BL Series will not send a read error code. Specify the ID number as a value between 1 to Be sure not to set the same number for different BL units in the same multi-drop link.
Page 58 Specify the model of the PLC to be connected. The data is not sent. Set the items for [Options]. Page Utility]] Screen Do not change from the initial value. Specify the scale factor of the quiet zone with reference to the narrow bar width the narrowest bar width in the bar code. Do not change You can send data to the BL by setting the communication parameters of the host computer using [[Com Port]] so that they Check or change the communication parameter settings of the personal com- puter.
Page 66 Check that [[Com port]] is set as shown in 3. Reading succeeded Reading failed 6. Page 68 Series. Then, click the [Read BL settings] button. To avoid problems, read the settings of the BL Series first, then change only the necessary items.
In this case, when you read the settings of the BL Series the next time, you can also read the file name to check the name of the current file of the BL Series. Click the [Compare] button. Select a saved file to be compared and click the [OK] button. The selected saved file is compared with the file currently being edited. Page Command Transmission Setup Software 3.
Receive the bar code data. Page 74 3. Now, commands pages to Note: When the scanning width is changed, the laser beam may not be properly applied to the bar codes, resulting in poor readings.
When the setting is complete, quit the test mode. Click the [QUIT] button. Page 80 Chapter 4 Setup Software Page 81 Chapter 5 Installation This chapter describes the procedure and cautions for the installation of the BL Series and special power supply unit. Installation of the BL Series Page 83 Keep a distance BL Series between the units. If two or more bar code labels enter the laser beam at the same time, the BL cannot be set to read a specific bar code.
Keep a distance between the bar codes. Otherwise, the specular reflections may cause unstable reading or reading errors. Temporarily fix the mounting bracket. Page 86 5. Check the surroundings and adjust the mounting distance and angle. Page 88 5. Temporarily mount the BL Series in position. Page 90 Installation 5. Fasten the BL Series. Fasten the BL Series in the mounting position with M3 screws. Select the M3 screws after checking the panel thickness and other factors of the mounting position.
The mounting hole for the BL Series is 4 mm deep. Check that the DIN-rail mounting claw is in the condition shown in the figure. Front view DIN-rail mounting claw 2. Page 94 Chapter 5 Installation Read Operation Select an appropriate method according to the application. It requires a maximum of 3 scans 6 ms to adjust gain. The BL generates a maximum of 6 ms delay until starting to read the data after the laser beam turns ON.
Com- parison to the preset data is not performed. Page Multi-Label Read Mode 3 Multi 3 Series can simultaneously read all the bar codes, provided the data of all the bar codes is different. A variety of data exports are available for download. All Products: Download all parts. Reedy's SCBL Brushless ESC is water-resistant for maximum reliability and features a compact footprint that allows for easy installation in most vehicles.
The latest electronics technology along with the design and engineering experience that is responsible for 30 World Championship titles has been incorporated into its design. Expert drivers will enjoy the SCBL's track-tested precision brake and throttle feel.
0コメント