Cisco 800 series management software

In the following configuration example, the aggregator is configured as a PPPoE server. Cisco F routers have a Gigabit Ethernet GE port that supports copper connections or a small-form-factor pluggable SFP port that supports fiber connections. Media can be configured for failover redundancy when the network goes down. To assign primary and secondary failover media on the GE-SFP port, perform these steps, beginning in global configuration mode.

The Auto-Detect feature is enabled if media-type is not configured. This feature automatically detects which media is connected and links up. If both media are connected, whichever media comes up first is linked up. To configure the Auto-Detect feature, perform the following steps, starting in global configuration mode:. Enables Auto-Detect. If a Base SFP is plugged in, the speed and duplex are set automatically to and full. Speed and duplex options are not available.

An RJ45 connection will only work with speed as and duplex as full. From Release Skip to content Skip to search Skip to footer. Book Contents Book Contents. Find Matches in This Book. PDF - Complete Book 6.

Updated: May 3, For information on configuring voice backup, see Configuring Voice Functionality. On Cisco sries and Cisco series ISRs, the console port and the auxiliary port are on the same physical RJ port; therefore, the two ports cannot be activated simultaneously. You must use the CLI to enable the desired function.

Cisco F ISRs have a Gigabit Ethernet GE port that supports copper connections or a small-form-factor pluggable SFP port that supports fiber connections and can be configured for failover redundancy when the network goes down. Step 1. This interface can be a serial, ISDN, or asynchronous.

Step 2. Assigns an interface as the secondary, or backup interface. Step 3. You cannot configure a backup interface for the cellular interface and any other asynchronous serial interface. Enables dialer watch on the backup interface.

Step 4. Defines a list of all IP addresses to be watched. Step 5. Creates a dialer list for traffic of interest and permits access to an entire protocol.

Step 6. Defines traffic of interest. Step 7. Step 8. You can also use this command to display the power usage and the power consumption of the unit at the end. The Cisco ISRs have hardware and software features for reducing power consumption. The hardware features include high-efficiency AC power supplies and electrical components with built-in power saving features, such as RAM select and clock gating. The software features include Cisco EnergyWise, a power efficiency management feature that powers down unused modules and disable unused clocks to the modules and peripherals on the router.

Detailed configuration procedures are included in. Skip to content Skip to search Skip to footer. See specific router model documentation for information about supported features:. Cisco EnergyWise monitors and manages the power usage of network devices and devices connected to the network. For information about using EnergyWise technology, see the configuration guides at the following site:. Cisco EnergyWise Configuration Guides. Beginning in privileged EXEC mode, perform these steps.

Router configure terminal.